Controller TITANIC +

Description

Titanic is a controller designed to control the operation of the C.H. boiler with a feeding screw or a ram feeder (with a feeder position sensor). This controller has the ability to control the device depending on the weather. After connecting an additional external temperature sensor, the controller calculates the boiler setting according to the heating curve set by the user. In addition, Titanic controller supports the remote control - (PILOT) a remote control or room thermostat. These devices increase the user's comfort of controller operation by the possibility to stabilize the temperature in the room.

Special features

Functions

- a flexible adjustment of the blower speed
- controlling the feeding screw or a ram feeder
- control of a C.H. circulating pump
- controlling the pump that feeds the H.T.W. tank
- using a remote control (PILOT) or a room thermostat
- the ability to control the temperature of the boiler depending on the weather*
- weekly control of the C.H. and H.T.W. circuit
- modes of operation SUMMER (the operation of only a pump supplying the H.T.W. tank), H.T.W. PRIORITY (heating the H.T.W. tank first), NO H.T.W. (switching the H.T.W. pump off)
- an anti-freeze system below 5°C
- an anti-stop system to prevent the stopping of pumps
- easy to read LCD display
- easy to use menu
* weather sensor must be purchased separately

Versions

1S - Version for the installation on the boiler or next to the boiler on the wall, a panel at an angle, cables extending from the rear of the controller housing

1T - A version for installing on the boiler or next to the boiler on the wall, the panel at an angle, the cables extending from the back of the controller housing, housing made of plastic, wires terminated with network sockets. Sensors disassembled with couplings

0S - The high boiler version, where using the 1S case could have problems with the keys

2S - The 2S housing allows the assembly of some of the wiring under the insulation of the boiler. Inside there is an operating module mounted on the bus, which greatly simplifies installation and removal of the module

3S - The 3S housing, a version for mounting on the boiler or a tank with fuel; the holes in the bottom of the controller allow placing some of the wiring under the insulation of the boiler

1S FULL - The full 1S housing allows full assembly of some of the wiring under the insulation of the boiler, the panel is mounted in the front wall of the boiler

module + panel - working module and a panel, separately (without the metal casing). Special operator's panel with locks enables it to be mounted on the facade of the boiler. The working module has special locks with which it is mounted on 35mm DIN bus

One-piece PS drawer housing - a version for installation in its entirety under the insulation of the boiler. The operator's panel mounted on the front of the boiler insulation. On the back of the housing, sockets for connecting devices

Two-piece PS drawer housing - a version for installation in its entirety under the insulation of the boiler, operator's panel mounted in the front of the boiler insulation. Z tyłu gniazda sieciowe do przyłączenia urządzeń – On the back, sockets for connecting devices

Wersje wzmocnione

- wersja wzmocniona: dmuchawa 550W podajnik 250W pompy 250W dostępna w obudowach 1S, 1S pełnej, 0S (tutaj już bez zdjęcia tylko taka informacja że są dwie wersje wzmocnione)

- wersja wzmocniona dmuchawa, podajnik pod stycznik: pod wyjście podajnik można podłączyć cewkę stycznika, dmuchawa wzmocniona 550W pompy 250W, dostępna w obudowach 1S, 1S pełnej, 0S

Regulator operating system