Description
Krypton P controller is a modern regulator for fine coal and hopper boilers. Different types of housing, in which the controller is available allow mounting the regulator on the boiler or a tank with fuel, on the wall in the boiler room, under the boiler construction, in the control cabinet, on a bus. Krypton P microprocessor controller is designed to control the blower and a circulating pump in the C.H. systems. It has an output for connecting a remote control.
Language versions
Special features
Functions
- controlling a C.H. circulating pump
- using a remote control (PILOT) or a room thermostat
- an anti-freeze system below 5°C
- an anti-stop system to prevent the stopping of pumps
- the ability to set the minimum and maximum blower speed (operation with different types of blowers)
- gradual switching the blower from minimum to maximum speed
- fuel shortage check
- easy to read LED display
- easy to use menu
- available in various types of housings
* The regulator is also available in the enhanced version (for high power boilers, supporting two blowers)
Versions
Krypton P controller in a 1S housing - Version for the installation on the boiler or next to the boiler on the wall, a panel at an angle, cables extending from the rear of the controller housing
Krypton P controller in a 0S housing - Version for installation on high boilers, where the use of the 1S casing could cause problems with the operation of the keys
Krypton P controller in the 1T plastic housing - A version for installing on the boiler or next to the boiler on the wall, the panel at an angle, the cables extending from the back of the controller housing, housing made of plastic, wires terminated with network sockets. Sensors disassembled with couplings
Krypton P controller in a 2S housing - The 2S housing allows the assembly of some of the wiring under the insulation of the boiler. Inside there is an operating module mounted on the bus, which greatly simplifies installation and removal of the module
Krypton P controller in the 3S housing - The 3S housing, a version for mounting on the boiler or a tank with fuel; the holes in the bottom of the controller allow placing some of the wiring under the insulation of the boiler
Krypton P controller in a full 1S housing - The full 1S housing allows full assembly of some of the wiring under the insulation of the boiler, the panel is mounted in the front wall of the boiler
Krypton P controller in SW2 housing - Version designed for servicing large boilers. it can handle two large blowers of 550W each. The use of the housing with a DIN rail allows the installation of additional contactors, e.g. for three-phase pumps
Reinforced version: possibility of connecting two 2 x 250W or one 550W blowers, and a pump up to 250W. The version is available in 1S, 0S casings
Regulator operating system
